Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2012 >> Eclipse GS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Manual Transaxle Overhaul) >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>N<< 5TH Speed-Reverse Synchronizer Hub Installation

>>N<< 5TH Speed-Reverse Synchronizer Hub Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set the output shaft on the press support stand.
  2. Make sure that the synchronizer ring is fitted correctly on the cone of the 5th speed gear.
  3. Check that the 5th speed-reverse synchronizer hub is oriented correctly for installation, and install it on the output shaft.
    Fig 1: Identifying 5th Speed-Reverse Synchronizer Hub
    G06684613Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Using special tools MD98812, MD998813 and MD998819, press install the 5th speed-reverse synchronizer hub with the press.
  5. Make sure that the synchronizer ring on the 5th speed gear side can rotate freely.
Fig 2: Identifying Special Tools MD98812, MD998813 And MD998819
G06684614Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals