Oscilloscope Inspection Procedures

With the connector remain connected, connect the oscilloscope probe to each terminal of TCM.

OSCILLOSCOPE INSPECTION PROCEDURES TABLE

Terminal No.	Check item	Check conditions	Normal conditions	Wave patterns
36 - 26	Secondary pulley rotation sensor	Transmission range: D Drive at a constant speed of Approximately 20 km/h (12 mph)	Between 0 and 4.5 V, the pulse cycle is constant.	Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
37 - 26	Primary pulley rotation sensor		Between 0 and 4.5 V, the pulse cycle is constant.	Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.