Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2011 >> Endeavor LS, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> On-Vehicle Service >> Auto-Cruise Control System Component Check >> Stoplight Switch

Stoplight Switch

  1. Disconnect the connector.
  2. Check for continuity between the terminals of the switch.
    MEASUREMENT CONDITION CHART

    MEASUREMENT CONDITION TERMINAL CONNECTOR OF TESTER SPECIFIED CONDITION
    When brake pedal is depressed. 1 - 2 (for stoplight circuit) Continuity (Less than 2 ohms)
    3 - 4 (for auto-cruise control circuit) Open circuit
    When brake pedal is not depressed. 1 - 2 (for stoplight circuit) Open circuit
    3 - 4 (for auto-cruise control circuit) Continuity (Less than 2 ohms)
    Fig 1: Identifying Stoplight Switch Connector Terminals
    G06246573Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals