Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2011 >> Eclipse GS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transaxle System) >> Transaxle Assembly >> Removal And Installation >> Installation Service Point >> >>E<< Transaxle Control Cable/Adjusting Nut Installation

>>E<< Transaxle Control Cable/Adjusting Nut Installation

WARNING: This page is about a different variant/trim than selected.
  1. Place the selector lever and manual control lever in the "N" position.
  2. Place the cable stud into the manual control lever slot and install the nut loosely. Gently push the transaxle control cable into the manual control lever slot until the cable is taut. Tighten the nut to the specified torque.

    Tightening torque: 12 ± 2 N.m (107 ± 17 in-lb) 

    Fig 1: Installing Manual Control Cable/Adjusting Nut With Torque Specifications
    G05102662Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.


  1. Place the selector lever and manual control lever in the "N" position.
  2. Place the cable stud into the manual control lever slot and install the nut loosely. Gently push the transaxle control cable into the manual control lever slot until the cable is taut. Tighten the nut to the specified torque.

    Tightening torque: 12 ± 2 N.m (107 ± 17 in-lb) 

    Fig 1: Locating Manual Control Lever
    G05102685Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals