Brake Pad Check

WARNING: This page is about a different variant/trim than selected.

CAUTION: If there is a significant difference in thickness between the brake pads at right and left, check the sliding area and the run-out of the brake disc (Refer to DISC BRAKE ROTOR CHECK ).

Visually check the thickness of brake pad from the inspection hole of the caliper body.
Standard value: 10.0 mm (0.39 inch)

Limit: 2.0 mm (0.08 inch)
If the brake pad thickness is less than the limit value, replace the brake pad (Refer to BRAKE PAD REPLACEMENT <EXCEPT RALLIART> <Except RALLIART> or BRAKE PAD REPLACEMENT <RALLIART> <RALLIART>).

Fig 1: Locating Inspection Hole Of Caliper Body - Front (Except Ralliart)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Locating Inspection Hole Of Caliper Body - Front (Ralliart)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Locating Inspection Hole Of Caliper Body - Rear
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.