Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2010 >> Lancer ES, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Active Stability Control System (ASC) - Lancer SPORTBACK) >> Wheel Speed Sensor >> Inspection >> Wheel Speed Sensor Current Check

Wheel Speed Sensor Current Check

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not connect the battery terminals in reverse as the wheel speed sensor may be damaged.
  1. Connect the circuit tester to the wheel speed sensor using the special tool extra fine probe (MB992006), and measure the sensor current as a single unit.

    Standard value: 5.9 to 8.4 mA or 11.8 to 16.8 mA 

  2. If the measurement value is not within the standard value range, replace the wheel speed sensor with a new one.
Fig 1: Checking Wheel Speed Sensor For Current
G05376435Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals