Auto-Cruise Control
- Auto-Cruise Control
- General Information
- Construction Diagram
- Auto-Cruise Control System Diagnosis
- Diagnostic Trouble Code (DTC) Chart
- Diagnostic Trouble Code Procedures
- Symptom Chart
- Symptom Procedures
- Notes
- Inspection Procedure 1: When the Brake Pedal is Depressed, Cruise Control System is not Cancelled
- Inspection Procedure 2: When the Clutch Pedal is Depressed, Cruise Control System is not Cancelled.
- Inspection Procedure 3: When the Selector Lever is Moved to "N" Position, Cruise Control System is not Cancelled.
- Inspection Procedure 4: When the Shift Lever is Moved to "N" Position, Cruise Control System is not Cancelled.
- Inspection Procedure 5: When the "CANCEL" Switch is Pressed, Cruise Control System is not Cancelled
- Inspection Procedure 6: Cruise Control System cannot be Set (No Response when the "COAST/SET" Switch and the "ACC/RES" Switch is Pressed.) (2.0L ENGINE Non-turbo, 2.4L ENGINE)
- Inspection Procedure 7: Cruise Control Cannot be Set ("COAST/SET" or "ACC/RES" Switch Operation is not Available.) (2.0L ENGINE Turbo)
- Inspection Procedure 8: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed.
- Inspection Procedure 9: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed.
- Inspection Procedure 10: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed.
- Inspection Procedure 11: When the "ON/OFF" Switch is Turned ON, "CRUISE" Indicator Light Inside Combination Meter does not Illuminate (However, Cruise Control System is Normal.)
- Data List Reference Table
- ECM Terminal Voltage Reference Chart For Cruise Control System Operation
- Special Tools
- On-Vehicle Service
- Auto-Cruise Control Switch