Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2009 >> Eclipse GS, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Traction Control/Active Skid Control System >> TCL/ASC Diagnosis >> Check At TCL/ASC-Ecu >> Resistance And Continuity Between Harness-Side Connector Terminals

Resistance And Continuity Between Harness-Side Connector Terminals

  1. Disconnect the connector A-38, and connect special tool MB991997 to the wiring harness-side connector.
    NOTE: Do not connect special tool MB991997 to the TCL/ASC-ECU.
  2. Measure the resistance and continuity between the terminals indicated in the table below.
    Fig 1: Locating TCL/ASC-ECU Connector A-38
    G05435465Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    NORMAL CONDITION

    CONNECTOR TERMINAL NO. SIGNAL NORMAL CONDITION
    45-46 Front-left wheel speed sensor 1.24-1.64 kΩ
    33-34 Front-right wheel speed sensor 1.24-1.64 kΩ
    36-37 Rear-left wheel speed sensor 1.24-1.64 kΩ
    42-43 Rear-right wheel speed sensor 1.24-1.64 kΩ
    16 - body ground Ground Less than 2 ohms
    47 - body ground Ground Less than 2 ohms
scientia non olet · About Mike's Workshop Manuals