Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2008 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Auto-Cruise Control - Lancer Evolution) >> Auto-Cruise Control >> On-Vehicle Service >> Cruise Control System Component Check >> Clutch Switch Check < M/T >

Clutch Switch Check < M/T >

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the clutch switch harness connector.
  2. Check for continuity between the terminals of the switch.
    TERMINAL CONNECTOR AND SPECIFIED CONDITION

    Measurement condition Terminal connector of tester Specified condition
    When clutch pedal is depressed. 1 - 2 Continuity (less than 2 ohms)
    When clutch pedal is not depressed. 1 - 2 Open circuit
    Fig 1: Identifying Clutch Switch And Clutch Pedal Assembly
    G05393814Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals