Symptom Chart

WARNING: This page is about a different variant/trim than selected.

NOTE: For additional Symptom Chart information, refer to TSB UPDATED CRUISE CONTROL DIAGNOSIS - SERVICE MANUAL REVISION .

SYMPTOM CHART

Symptom		Reference
Communication with scan tool is not possible	Communication with the ECM only is impossible	MFI Diagnosis, Symptom Procedures - INSPECTION PROCEDURE 1: COMMUNICATION WITH ECM ONLY IS NOT POSSIBLE
Cruise control is not cancelled.	When brake pedal is depressed	INSPECTION PROCEDURE 1: WHEN THE BRAKE PEDAL IS DEPRESSED, CRUISE CONTROL SYSTEM IS NOT CANCELLED.
	When clutch pedal is depressed < M/T >	INSPECTION PROCEDURE 2: WHEN THE CLUTCH PEDAL IS DEPRESSED, CRUISE CONTROL SYSTEM IS NOT CANCELLED < M/T >.
	When shift lever is moved to "N" position < TC-SST >	INSPECTION PROCEDURE 3: WHEN THE SHIFT LEVER IS MOVED TO "N" POSITION, CRUISE CONTROL SYSTEM IS NOT CANCELLED < TC-SST >.
	When "CANCEL" switch is turned ON	INSPECTION PROCEDURE 4: WHEN THE CRUISE CONTROL "CANCEL" SWITCH IS SET TO ON, CRUISE CONTROL SYSTEM IS NOT CANCELLED.
Cruise control cannot be set ("COAST/SET" or "ACC/RES" switch operation is not available).		INSPECTION PROCEDURE 5: CRUISE CONTROL CANNOT BE SET ("COAST/SET" OR "ACC/RES" SWITCH OPERATION IS NOT AVAILABLE).
Hunting (repeated acceleration and deceleration) occurs at the set vehicle speed.		INSPECTION PROCEDURE 6: HUNTING (REPEATED ACCELERATION AND DECELERATION) OCCURS AT THE SET VEHICLE SPEED.
When "ON/OFF" switch is turned ON, "CRUISE" indicator light inside combination meter does not illuminate. (However, cruise control system is normal).		INSPECTION PROCEDURE 7: WHEN "ON/OFF" SWITCH IS TURNED ON, "CRUISE" INDICATOR LIGHT INSIDE COMBINATION METER DOES NOT ILLUMINATE (HOWEVER, CRUISE CONTROL SYSTEM IS NORMAL).