Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2008 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Auto-Cruise Control - Lancer >> On-Vehicle Service >> Auto-Cruise Control Switch Check >> Auto-Cruise Control System Component Check >> Stoplight Switch Check

Stoplight Switch Check

  1. Disconnect the stoplight switch harness connector.
  2. Check for continuity between the terminals of the switch.
    3. Fig 1: Identifying Stoplight Switch Connector Terminals
    G05375521Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CONTINUITY REFERENCE

Measurement condition Terminal connector of tester Specified condition
When brake pedal is depressed. 1 - 2 (for stoplight switch) Continuity (less than 2 ohms)
3 - 4 (for brake switch) Open circuit
When brake pedal is not depressed. 1 - 2 (for stoplight switch) Open circuit
3 - 4 (for brake switch) Continuity (less than 2 ohms)
scientia non olet · About Mike's Workshop Manuals