Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2008 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Auto-Cruise Control - Lancer >> On-Vehicle Service >> Auto-Cruise Control Switch Check >> Auto-Cruise Control Main Switch Check >> Auto-Cruise Control Setting

Auto-Cruise Control Setting

  1. Switch the "ON/OFF" switch to "ON".
    2. Fig 1: Locating ON/OFF (MAIN) Switch
    G05375509Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Drive at the desired speed, above approximately 40 km/h (25 mph).
  3. Push the "COAST/SET" switch.
    4. Fig 2: Locating COAST/SET Switch
    G05375512Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Check to be sure that when the "COAST/SET" switch is released the speed is the constant speed.
NOTE: If the vehicle speed decreases to approximately 15 km/h (9 mph) below the set speed because of climbing a hill for example, it is normal for the auto-cruise control to be cancelled. When the vehicle speed becomes approximately 40 km/h (25 mph) or less, driving at constant speed will be cancelled even if the vehicle speed does not decrease 15 km/h (9 mph) or more.
scientia non olet · About Mike's Workshop Manuals