Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2008 >> Lancer ES, Automatic CVT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Auto-Cruise Control - Lancer >> On-Vehicle Service >> Auto-Cruise Control Switch Check >> Auto-Cruise Control Main Switch Check >> Speed-Reduction Setting

Speed-Reduction Setting

  1. Switch the "ON/OFF" switch to "ON".
    2. Fig 1: Locating ON/OFF (MAIN) Switch
    G05375509Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Set to the desired speed, above approximately 40 km/h (25 mph).
  3. Push the "COAST/SET" switch.
    4. Fig 2: Locating COAST/SET Switch
    G05375512Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Check to be sure that deceleration continues while the "COAST/SET" switch is pushed, and that the speed at the time it was released becomes the constant driving speed.
NOTE: When the vehicle speed reaches the low limit [approximately 40 km/h (25 mph)] during deceleration, the auto-cruise control will be cancelled.
scientia non olet · About Mike's Workshop Manuals