Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Systems >> Switch - Seat - Driver >> Removal

Switch - Seat - Driver: Removal

Fig 1: Identifying Power Seat Switch Assembly, Front Seat Cushion Side Shield, Screws And Recliner Lever
G04859251Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the screw (4) that secures the recliner lever (5) to the recliner mechanism release shaft on the outboard side of the driver side front seat cushion side shield (2).
  3. Pull the recliner lever (5) off of the recliner mechanism release shaft.
  4. Remove the two screws (3) and (6) that secure the driver side seat cushion side shield (2) to the outboard seat cushion frame.
  5. Pull the driver side seat cushion side shield (2) away from the seat cushion frame far enough to access the power seat switch assembly (1) wire harness connector.
    Fig 2: Identifying Seat Cushion Side Shield, Power Seat Switch And Screws
    G04859252Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Unplug the wire harness connector from the power seat switch module.
  7. Remove the seat cushion side shield and power seat switch module from the seat as a unit.
  8. Remove the two screws (3) that secure the power seat switch (2) to the inside of the seat cushion side shield (1).
  9. Remove the power seat switch from the seat cushion side shield.
scientia non olet · About Mike's Workshop Manuals