Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2007 >> Outlander LS, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Wireless Control Module (WCM) >> On-Vehicle Service >> Id Codes Registration Procedure >> "Keyless Id Reg." Method

"Keyless Id Reg." Method

Fig 1: M.U.T.-III Display - OK Button
G04872624Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. On the "Keyless ID Reg." screen, enter the password and press the OK button.
  2. Register within 1 minute and send the programming packet* to register the keyless ID. To register multiple keys, register the next key within 1 minute from the registration operation of previous key. Complete the registration of necessary keys, then press the OK button to finish the keyless ID registration.
    NOTE:
    • Up to eight ignition keys can be registered.
    • *: Programming packet sending procedure Complete the following steps  1 to  3 within four seconds.
      1. Press and hold both the lock and the unlock switch for 1 second or longer.
      2. Release both the lock and the unlock switch for 0.5 second or longer.
      3. Press the unlock switch.
  3. Push the OK button after "Keyless ID Registration was finished." is displayed.
    Fig 2: M.U.T.-III Display - Work Of Regist Ratio
    G04872625Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Check number of the keyless IDs registered.
scientia non olet · About Mike's Workshop Manuals