Auto-Cruise Control System
- General Information
- Auto-Cruise Control System Diagnosis
- Introduction To Auto-Cruise Control System Diagnosis
- Diagnostic Troubleshooting Strategy
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- Symptom Chart
- Symptom Procedures
- Notes
- Inspection Procedure 1: When the Brake Pedal is Depressed, Auto-cruise Control System is not Cancelled
- Inspection Procedure 2: When the Selector Lever is Moved to "N" Position, Auto-cruise Control System is not Cancelled
- Inspection Procedure 3: When the Auto-cruise Control "CANCEL" Switch is Set to ON, Auto-cruise Control System is not Cancelled
- Inspection Procedure 4: Auto-cruise Control System cannot be Set
- Inspection Procedure 5: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed
- Inspection Procedure 6: When "ON/OFF" Switch is Turned "ON", "CRUISE" Indicator Light Inside Combination Meter does not Illuminate (However, Auto-cruise Control System is Normal)
- Data List Reference Table
- ECM Terminal Voltage Reference Chart For Auto-Cruise Control System Operation
- Special Tools
- On-Vehicle Service
- Auto-Cruise Control