Fastener Tightening Specifications
WARNING: This page is about a different car, the 2005 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
FASTENER TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION |
|---|---|
| Transmission oil replacement | |
| Drain plug | 32 +/- 2 N-m (24 +/- 1 ft-lb) |
| Filler plug | 32 +/- 2 N-m (24 +/- 1 ft-lb) |
| Transaxle control | |
| Gearshift lever assembly attaching bolt | 12 +/- 2 N-m (102 +/- 22 in-lb) |
| Gearshift lever knob <2.4L ENGINE> | 6.0 +/- 1.5 N-m (53 +/- 13 in-lb) |
| Select lever retainer nut | 10 +/- 1 N-m (84 +/- 13 in-lb) |
| Shift cable and select cable assembly attaching bolt | 12 +/- 2 N-m (102 +/- 22 in-lb) |
| Shift lever retainer nut | 14 +/- 5 N-m (120 +/- 22 in-lb) |
| Transaxle assembly | |
| Cable bracket and shift cable assembly attaching bolt | 18 +/- 3 N-m (13 +/- 2 ft-lb) |
| Center bearing bracket bolt (RH) <2.4L ENGINE> | 41 +/- 4 N-m (30 +/- 3 ft-lb) |
| Center member attaching bolt | 69 +/- 10 N-m (51 +/- 7 ft-lb) |
| Clutch release cylinder and clutch oil pipe attaching bolt | 18 +/- 3 N-m (13 +/- 2 ft-lb) |
| Cover (engine side) attaching bolt <2.4L ENGINE> | 9.0 +/- 1.0 N-m (80 +/- 9 in-lb) |
| Cover (transaxle side) attaching bolt <2.4L ENGINE> | 26 +/- 5 N-m (19 +/- 4 ft-lb) |
| Cover attaching bolt <2.0L ENGINE> | 7.0 +/- 1.0 N-m (62 +/- 9 in-lb) |
| Drive shaft connecting nut | 245 +/- 29 N-m (181 +/- 21 ft-lb) |
| Front roll stopper bracket retainer nut | 52 +/- 7 N-m (39 +/- 5 ft-lb) |
| Lower arm connecting nut | 108 +/- 10 N-m (80 +/- 7 ft-lb) |
| Rear roll stopper bracket attaching bolt | 70 +/- 10 N-m (52 +/- 7 ft-lb) |
| Self-locking nut (tie rod end connection) | 25 +/- 5 N-m (19 +/- 3 ft-lb) |
| Starter motor coupling bolt | 48 +/- 6 N-m (36 +/- 4 ft-lb) |
| Transaxle assembly lower part coupling bolt | 48 +/- 5 N-m (36 +/- 3 ft-lb) |
| Transaxle assembly upper part coupling bolt | 48 +/- 6 N-m (36 +/- 4 ft-lb) |
| Transaxle mount bracket attaching nut | 47 +/- 7 N-m (35 +/- 5 ft-lb) |
| Transaxle mount stopper attaching nut | 82 +/- 7 N-m (61 +/- 5 ft-lb) |