Service Specifications
WARNING: This page is about a different variant/trim than selected.
SERVICE SPECIFICATIONS
| ITEM | STANDARD VALUE | LIMIT | |
|---|---|---|---|
| Power steering drive belt tension (When checked) | Vibration frequency Hz | 124-160 | - |
| Tension N (lb) | 294-490 (66-110) | - | |
| Deflection (Reference value) mm (in) | 12.3-16.2 (0.48-0.64) | - | |
| Power steering drive belt tension (When adjusted) | Vibration frequency Hz (Reference) | 134-151 | - |
| Tension N (lb) | 343-441 (77-99) | - | |
| Deflection (Reference value) mm (in) | 13.2-15.1 (0.52-0.59) | - | |
| Power steering drive belt tension (When replaced) | Vibration frequency Hz (Reference) | 160-189 | - |
| Tension N (lb) | 490-686 (110-154) | - | |
| Deflection (Reference value) mm (in) | 9.6-12.3 (0.38-0.48) | - | |
| Generator drive belt tension (When checked) | Vibration frequency Hz | 143-169 | - |
| Tension N (lb) | 490-686 (110-154) | - | |
| Deflection (Reference value) mm (in) | 8.4-10.7 (0.33-0.42) | - | |
| Generator drive belt tension (When adjusted) | Vibration frequency Hz (Reference) | 150-163 | - |
| Tension N (lb) | 539-637 (121-143) | - | |
| Deflection (Reference value) mm (in) | 8.9-10.1 (0.35-0.40) | - | |
| Generator drive belt tension (When replaced) | Vibration frequency Hz (Reference) | 180-202 | - |
| Tension N (lb) | 785-981 (176-221) | - | |
| Deflection (Reference value) mm (in) | 6.2-7.5 (0.24-0.30) | - | |
| Intake valve clearance (at hot) mm (in) | 0.20 (0.008) | - | |
| Basic ignition timing at idle | 5°BTDC ± 3° | - | |
| Actual ignition timing at curb idle | Approximately 10° BTDC | - | |
| CO contents % | 0.5 or less | - | |
| HC contents ppm | 100 or less | - | |
| Curb idle speed r/min | 680 ± 100 | - | |
| Compression pressure (200 r/min) kPa (psi) | 1,550 (225) | Minimum 1,110 (161) | |
| Compression pressure difference of all cylinder kPa (psi) | - | 98 (14) | |
| Intake manifold vacuum at curb idle kPa (in Hg) | - | Minimum 60 (18) | |
| Cylinder block heater unit internal resistance Ω | 19-30 | - | |
| Timing belt tension torque N.m (in-lb) | 4.4 (39) | - | |
| Auto tensioner rod protrusion amount mm (in) | 4.8-6.0 (0.19-0.24) | - | |
| Auto-tensioner pushrod movement mm (in) | Within 1.0 (0.04) | - | |