Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2006 >> Lancer Evolution MR >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Overhaul) >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >>H<< Control Housing Installation

>>H<< Control Housing Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Squeeze sealant onto the case. Do not leave gaps or excess amounts, otherwise oil leaks are likely.
  1. Apply a 0.2 mm (0.08 inch) diameter bead of sealant (Mitsubishi Genuine Part number MD997740 or equivalent) as illustrated onto the control housing.
    NOTE: Be sure to install the housing to the case quickly while the sealant is still wet (within 15 minutes).
  2. Install the control housing to the transaxle case and tighten the bolts to specified torque.

    Tightening torque: 19 +/- 3 N.m (14 +/- 2 ft-lb) 

    NOTE: After installation, keep the sealed area away from the oil for approximately one hour.
    Fig 1: Applying Sealant Onto Control Housing
    G04275812Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals