Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2006 >> Lancer Evolution MR >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Overhaul) >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>N<< 5TH Speed-Reverse Synchronizer Hub Installation

>>N<< 5TH Speed-Reverse Synchronizer Hub Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set the output shaft on the press support stand.
  2. Make sure that the synchronizer ring is fitted correctly on the cone of the 5th speed gear.
  3. Check that the 5th speed-reverse synchronizer hub is oriented correctly for installation, and fit it on the output shaft.
    Fig 1: Installing 5Th Speed-Reverse Synchronizer Hub Is Oriented
    G04275865Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Using special tools MD98812, MD998813 and MD998819, press install the 5th speed-reverse synchronizer hub with the press.
  5. Make sure that the synchronizer ring on the 5th speed gear side can rotate freely.
    Fig 2: Checking Synchronizer Ring On 5Th Speed Gear Side Rotation
    G04275866Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals