Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2006 >> Lancer Evolution MR >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Overhaul) >> Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>E<< Synchronizer Ring Installation

>>E<< Synchronizer Ring Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: There are 3rd speed and 4th speed synchronizer rings, if the wrong one is installed it will effect the shift feeling.
  1. Ascertain whether or not there are identification notches on the synchronizer ring.

    Two notches: 3rd speed synchronizer ring 

    No notches: 4th speed synchronizer ring 

  2. Install the synchronizer ring so that it completely fits over the machined cone of the gear.
    Fig 1: Identifying Notches On Synchronizer Ring
    G04275826Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals