Repair and Diagnosis: Maintenance: Procedures: General
- How To Use This Information
- Troubleshooting Guidelines
- How To Use Troubleshooting/Inspection Service Points
- Troubleshooting Contents
- How To Use The Inspection Procedures
- Connector Measurement Service Points
- Notes
- If Inspecting With The Connector Connected < Waterproof Connectors >
- If Inspecting With The Connector Connected < Ordinary (Non-Waterproof) Connectors >
- If Inspecting With The Connector Disconnected < When Inspecting A Female Pin >
- If Inspecting With The Connector Disconnected < When Inspecting A Male Pin >
- Connector Inspection Service Points
- How To Cope With Intermittent Malfunctions
- Inspection Service Points For A Blown Fuse
- How To Treat Current Trouble
- How To Treat Past Trouble
- INTERSYSTEM Affiliated DTC Reference Table
- Vehicle Identification
- Precautions Before Service
- Supplemental Restraint System (SRS)
- How To Perform Vehicle Identification Number (VIN) Writing
- VIN Code Registration Procedure For ETACS-Ecu.
- Initialization Procedure For Learning Value In MFI Engine
- Learning Procedure For Idling In MFI Engine
- Servicing Electrical System
- Application Of Anti-Corrosion Agents And Undercoats
- Scan Tool (M.U.T.-III Sub Assembly)
- Towing And Hoisting
- General Data And Specifications
- Tightening Torque
- Lubrication And Maintenance
- Recommended Lubricants And Lubricant Capacities Table
- Scheduled Maintenance Table
- Maintenance Service
- 1. Fuel System (Tank, Pipe Line And Connection, And Fuel Tank Filler Tube Cap) (Check For Leaks)
- 2. Fuel Hoses (Check Condition)
- 3. Air Cleaner Element (Replace)
- 4. Evaporative Emission Control System (Except Evaporative Emission Canister) (Check For Clogging)
- 5. Spark Plugs (Replace)
- 6. Intake And Exhaust Valve Clearance (4G6-MIVEC Engine Only) (Inspect And Adjust)
- 7. Timing Belt (Replace)
- 8. Drive Belts (For The Generator And Power Steering Pump) (Check)
- 9. Exhaust System (Connection Portion Of Muffler, Muffler Pipes And Converter Heat Shields) (Check And Service)
- 10. Engine Oil (Change)
- 11. Engine Oil Filter (Replace)
- 12. Automatic Transaxle Fluid (Check Fluid Level And Condition)
- 13. Engine Coolant (Change)
- 14. Coolant Hoses (Radiator Hose, Heater Hose) (Inspect)
- 15. Disc Brake Pads, Rotors (Inspect For Wear)
- 16. Brake Hoses (Check For Deterioration Or Leaks)
- 17. Ball Joint And Steering Linkage Seals (Inspect For Grease Leaks And Damage)
- 18. Drive Shaft Boots (Inspect For Grease Leaks And Damage)
- 19. Suspension System (Inspect For Looseness And Damage)
- 20. Tires (Rotate)
- Main Sealant And Adhesive Table