Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2005 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (General (Electrical) -- Except Evolution) >> Harness Connector Inspection >> Rectangular Waterproof Connector >> Injector Connector

Injector Connector

WARNING: This page is about a different variant/trim than selected.
  1. Remove the waterproof cap.
    Fig 1: Removing Waterproof Cap
    G02458446Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Insert the tip of a screwdriver [1.4 mm (0.06 inch) width] into the connector as shown in the figure, press in the terminal lance, and pull out the terminal.
    CAUTION: Make sure the lance is pressed in before the terminal is inserted into the connector.
    Fig 2: Inserting Tip Of A Screwdriver Into Connector
    G02458447Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Press the contact point to the male terminal down by holding a screwdriver [1.4 mm (0.06 inch) width] as shown in the figure.
    Fig 3: Pressing Contact Point To Male Terminal
    G02458448Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals