Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2005 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Auto-Cruise Control (2.0L) - Except RALLIART) >> On-Vehicle Service >> Auto-Cruise Control Switch Check >> Auto-Cruise Control Setting

Auto-Cruise Control Setting

WARNING: This page is about a different variant/trim than selected.
  1. Switch "ON" the "CRUISE" (MAIN) switch.
  2. Drive at the desired speed, above approximately 40 km/h (25 mph).
  3. Push the auto-cruise control switch in the direction of arrow.
  4. Check to be sure that when the switch is released the speed is the desired constant speed.
    NOTE: If the vehicles speed decreases to approximately 15 km/h (9 mph) below the set speed because of climbing a hill for example, the auto-cruise control will be cancelled.
    Fig 1: Setting Auto-Cruise Control
    G02464233Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals