Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2005 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Auto-Cruise Control (2.0L) - Except RALLIART) >> Auto-Cruise Control System Diagnosis >> Auto-Cruise Control System Diagnostic Trouble Code Diagnosis >> Without Using Scan Tool MB991958

Without Using Scan Tool MB991958

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch to the "ON" position while holding the auto-cruise control switch in the "SET" (down) position. Then, within one second, more the cruise control switch up to the "RES" position.
  2. Check to make sure the "CRUISE" light on the instrument panel is flashing.
  3. Put the auto-cruise control switch in the "SET" (down) position. Depress the brake pedal and hold for five seconds or more. Release the brake pedal, auto-cruise control switch, then turn the ignition switch to the "LOCK" (OFF) position. The DTC(s) are now erased.
    Fig 1: Checking CRUISE Light
    G02464039Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals