Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2005 >> Eclipse GS, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Traction Control System >> Traction Control System (TCL) Diagnosis >> Resistance And Continuity Between Harness-Side Connector Terminals

Resistance And Continuity Between Harness-Side Connector Terminals

  1. Turn the ignition switch to the "LOCK" (OFF) position and disconnect the ABS-ECU connector before checking resistance and continuity.
  2. Check between the terminals indicated in the table below.
  3. The terminal layouts are shown in the table below.
    Fig 1: Identifying Connector Terminal
    G02461367Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    CONNECTOR TERMINAL - SIGNAL CONDITION

    CONNECTOR TERMINAL NO. SIGNAL NORMAL CONDITION
    6-7 Front-left wheel speed sensor 1.28-1.92 kohm
    1-3 Rear-right wheel speed sensor 1.28-1.92kohm
    4-5 Front-right wheel speed sensor 1.28-1.92kohm
    8-9 Rear-left wheel speed sensor 1.28-1.92kohm
    16-body ground Solenoid valve ground Less than 2ohm
    19-body ground Motor ground Less than 2ohm
    30-body ground TCL solenoid valve ground Less than 2ohm
scientia non olet · About Mike's Workshop Manuals