Fastener Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
FASTENER TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION |
|---|---|
| Air cleaner | |
| Air cleaner bracket bolt | 11 ± 1 N.m (98 ± 8 in-lb) |
| Air cleaner housing assembly bolt | 8.8 ± 1.0 N.m (78 ± 9 in-lb) |
| Air intake hose clamp bolt | 3.9 ± 1.0 N.m (35 ± 8 in-lb) |
| Mass airflow sensor bolt | 1.8 ± 0.6 N.m (16 ± 5 in-lb) |
| Exhaust manifold | |
| Exhaust manifold nut | 49± 5 N.m (36 ± 4 ft-lb) |
| Front exhaust pipe nut | 50 ± 10 N.m (37 ± 7 ft-lb) |
| Front exhaust pipe bracket bolt | 35 ± 5 N.m (26 ± 4 ft-lb) |
| Heat protector bolt | 14 ± 1 N.m (120 ± 13 in-lb) |
| Exhaust pipe and main muffler | |
| Center exhaust pipe nut | 59 ± 10 N.m (44 ± 7 ft-lb) |
| Front exhaust pipe bracket bolt | 35 ± 5 N.m (26 ± 4 ft-lb) |
| Front exhaust pipe nut | 50 ± 10 N.m (37 ± 7 ft-lb) |
| Hanger bolt | 13 ± 2 N.m (111 ± 22 in-lb) |
| Heated oxygen sensor (front) | 45 ± 5 N.m (34 ± 3 ft-lb) |
| Heated oxygen sensor (rear) | 45 ± 5 N.m (34 ± 3 ft-lb) |
| Main muffler bolt | 45 ± 5 N.m (34 ± 3 ft-lb) |
| Intake manifold | |
| Brake booster vacuum pipe bolt | 13 ± 2 N.m (111 ± 22 in-lb) |
| EGR valve bolt | 24 ± 3 N.m (18 ± 2 ft-lb) |
| Evaporative emission purge solenoid valve, evaporative emission vacuum hose and pipe assembly bolt | 11 ± 1 N.m (98 ± 8 in-lb) |
| Engine hanger bolt | 24 ± 3 N.m (18 ± 2 ft-lb) |
| Harness cramp | 11± 1 N.m (98 ± 8 in-lb) |
| Intake manifold bolt | 24 ± 3 N.m (18 ± 2 ft-lb) |
| Intake manifold nut | 20 ± 2 N.m (15 ± 1 ft-lb) |
| Intake manifold stay bolt | 31± 3 N.m (23 ± 2 ft-lb) |
| Knock sensor connector cramp bolt | 11 ± 1 N.m (98 ± 8 in-lb) |
| Manifold absolute pressure sensor bolt | 5.0 ± 1.0 N.m (44 ± 9 in-lb) |
| Oil dipstick guide bolt | 13 ± 1 N.m (115 ± 9 in-lb) |
| Thermostat case assembly bolt | 24 ± 4 N.m (18 ± 3 ft-lb) |