Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2004 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Automatic Transaxle On-Vehicle Service) >> Transaxle Control >> Installation Service Points >> >>C<< Nut Installation

>>C<< Nut Installation

WARNING: This page is about a different car, the 2004 Mitsubishi Eclipse. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the transaxle manual control lever in the "N" position.
  2. Place the selector lever in the "N" position.
    3. Fig 1: Installing Transaxle Control Cable Nut
    G03278980Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Place the cable stud into the manual control lever slot and install the nut loosely. Gently push the transaxle control cable in the direction of the arrow until the cable is taut Tighten the nut to the specified torque.

    Tightening torque: 12 plus/minus 2 N-m (102 plus/minus 22 in-lb)

scientia non olet · About Mike's Workshop Manuals