Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2004 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Manual Transaxle Overhaul) >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>P<< 5TH Speed-Reverse Synchronizer Hub Installation

>>P<< 5TH Speed-Reverse Synchronizer Hub Installation

WARNING: This page is about a different car, the 2004 Mitsubishi Eclipse. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the output shaft on the press support stand.
  2. Make sure that the synchronizer ring is fitted correctly on the cone of the 5th speed gear.
  3. Check that the 5th speed-reverse synchronizer hub is oriented correctly for installation, and fit it on the output shaft.
    Fig 1: Checking 5Th Speed-Reverse Synchronizer Hub Installation Direction
    G03305713Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Using special tools MD98812, MD998813, MD998819 < F5M42>, MD998821 < F5M51> and MD998364 < F5M51>, press install the 5th speed-reverse synchronizer hub with the press.
  5. Make sure that the synchronizer ring on the 5th speed gear side can rotate freely.
    Fig 2: Installing 5Th Speed-Reverse Synchronizer Hub (F5M42)
    G03305714Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    6. Fig 3: Installing 5Th Speed-Reverse Synchronizer Hub (F5M51)
    G03305715Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals