Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Front Suspension - Except Evolution) >> Disassembly & Reassembly >> Axle Hub Assembly >> Removal

Axle Hub Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove snap ring. See Fig 1 .
  2. Using Front Hub Remover and Installer (MB991017), Knuckle Arm Bridge (MB991056 or MB991355), and Front Hub Remover and Installer (MB991001 or MB990998), pull out the hub from the knuckle. See Fig 2 .
  3. Remove dust cover. See Fig 1 .
    4. CAUTION: When removing the inner race (outside) from the hub, be careful not to let the hub drop.
  4. Crush the oil seal in 2 places so that the tabs of the special tool will be caught on the wheel bearing inner race (outside). See Fig 3 . Using Side Bearing Puller (MB990810), remove the wheel bearing inner race (outside) from the front hub. See Fig 4 . Install the inner race (outside) that was removed from the hub to the wheel bearing, and then Installer Adapter (MB990935), Brass Bar (MB990938), and Knuckle Arm Bridge (MB991056 or MB991355) to remove the wheel bearing from knuckle. See Fig 5 .
Fig 1: Exploded View Of Front Axle Hub Assembly
G00356058Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 2: Removing Hub From Knuckle
G00356059Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 3: Locating Outer Oil Seal
G00356060Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 4: Removing Wheel Bearing Inner Race
G00356061Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 5: Removing Wheel Bearing
G00356062Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals