Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 1997 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.0L - Non-Turbo >> Circuit Tests >> DTC 93 - High Speed Condenser Fan Control Relay Circuit

DTC 93 - High Speed Condenser Fan Control Relay Circuit

NOTE: For terminal identification, see TERMINAL IDENTIFICATION  in SELF-DIAGNOSTICS section. For circuit and wire color identification, see WIRING DIAGRAMS - 2.0L - NON-TURBO article.
  1. Disconnect PCM connectors. Turn ignition on. Check voltage between ground and PCM A-106 connector terminal No. 19. If battery voltage exists, go to next step. If battery voltage does not exist, check condenser fan relay circuit.
  2. Turn ignition off. Connect jumper wire between ground and PCM A-106 connector terminal No. 19. Turn ignition on. If condenser fan runs at high speed, check PCM connectors. If PCM connectors are okay, replace PCM. If condenser fan does not run at high speed, check condenser fan relay circuit.
scientia non olet · About Mike's Workshop Manuals