Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 1996 >> Eclipse Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.0L Non-Turbo >> Circuit Tests >> DTC 135 - No 5 Volts To Map Sensor

DTC 135 - No 5 Volts To Map Sensor

NOTE: For component terminal identification, see TERMINAL IDENTIFICATION  in this article. For wiring diagrams, see WIRING DIAGRAMS  section.
  1. Disconnect MAP sensor connector. Check voltage between MAP sensor connector terminal No. 2 (Green/Yellow wire) and ground. If voltage is 4.8-5.2 volts, go to step 3). If voltage is not as specified, go to next step.
  2. Check PCM connector, junction connector connector and wiring harness between PCM and junction connector. If wiring and connectors are okay, go to next step.
  3. Check MAP sensor connector, PCM connector and wiring harness between PCM and MAP sensor. If wiring and connectors are okay, replace MAP sensor.
scientia non olet · About Mike's Workshop Manuals