Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 1987 >> Starion ESI-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Manual Transaxle On-Vehicle Service - Lancer Evolution) >> On-Vehicle Service >> Transfer Oil Check

Transfer Oil Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
  2. Remove the oil filler plug and gasket.
    Fig 1: Identifying Oil Filler Plug, Oil Drain Plug And Engine Oil Pan
    G05392273Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Check that the oil level is just below the lower edge of the oil filler plug hole.
  4. Check that the oil is not excessively foul and has moderate viscosity.
  5. Install the oil filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

    Fig 2: Identifying Oil Filler Plug
    G05393892Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Install the engine room under cover front B assembly. (Refer to UNDER COVER .)
scientia non olet · About Mike's Workshop Manuals