Engine Electrical System - Repair -- Cooper (F54)

• 12 00 Engine electrical system
  • Instructions for removal and replacement of control units (Cooper)
  • Notes on starting assistance (Cooper)
• 12 12 Ignition wire, spark plugs
  • Remove and install or replace all spark plugs (B36, B38, B46, B48) (Cooper)
• 12 13 Ignition coil
  • Replace ignition coils (B36, B38, B46, B48) (Cooper)
  • Replacing an ignition coil (after vehicle diagnosis) (Cooper)
    • REP-TAT-P-1213-01 Remove ignition coils
    • REP-TAT-P-1213-02 Installing the ignition coils
• 12 14 Electronic switching or control units
  • Replacing crankshaft pulse sensor (B36, B38, B46, B48) (Cooper)
  • Replacing pulse sensor on intake camshaft (B36, B38) (Cooper)
  • Replace pulse sensor on exhaust camshaft (B36, B38) (Cooper)
  • Replacing control unit (DME) (Cooper)
  • Replacing the knock sensor (B36, B38) (Cooper)
  • Programming the control unit (DME/DDE) (Cooper)
  • Replacing pulse sensor on intake camshaft (B48, B46) (Cooper S)
  • Replace pulse sensor on exhaust camshaft (B48, B46) (Cooper S)
  • Replacing the knock sensor (cylinder 1. and 2.) (B48, B46) (Cooper S)
  • Replacing knock sensor (cylinder 3. and 4.) (B48, B46) (Cooper S)
• 12 31 Alternator with drive and attachment
  • Removing and installing or replacing alternator (B36, B38) (Cooper)
  • Removing and installing or replacing alternator (B48, B46) (Cooper S)
• 12 41 Starter with attachment
  • Removing and installing/replacing starter motor (Cooper)
  • Replacing the engagement solenoid switch (Cooper)
• 12 42 Starter line
  • Replacing the positive battery cable from the vehicle battery to the starter motor (B36, B38) (Cooper)
  • Replacing the positive battery cable from the vehicle battery to the starter motor (B48, B46) (Cooper S)
• 12 51 Engine wiring harness
  • Replacing the wiring harness section for injectors and ignition coils (B36, B38, B46, B48) (Cooper)
  • Replacing the wiring harness section for the Valvetronic servomotor (B36, B38, B46, B48) (Cooper)
  • Replacing the wiring harness section for engine sensor system module 1 (B36, B38, B48, B46) (Cooper)
  • Replacing the wiring harness section for engine sensor system module 2 (B36, B38, B46, B48) (Cooper)
  • Removing and installing the wiring harness section for the supply module (B36, B38, B48, B46) (Cooper)
• 12 61 Oil pressure, oil temp, oil level check
  • Removing and installing/replacing the oil pressure switch (B36, B38, B46, B48) (Cooper)
  • Removing and installing/replacing oil level sensor for motor oil (Cooper)
• 12 63 Switch and relay
  • Replacing power distribution box (Cooper)