Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mini >> 2014 >> Cooper Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1254 (Engine Electrical System -- Repair (N54)) >> 00 Troubleshooting >> 12 00 ... Instructions for Removing and Installing Electronic Control Units

12 00 ... Instructions for Removing and Installing Electronic Control Units

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW 335xi, 2010 BMW 335i, 2009 BMW 335xi, 2009 BMW 335i, and 2008 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Disconnecting the vehicle battery will cancel the fault memories of control units. Consequently, before disconnecting the car's battery, always interrogate the fault memories. Investigate stored faults and, once any faults have been remedied, cancel the fault memory.
  • Control unit plugs should only ever be connected and disconnected while the ignition is turned off.
  • The removal and installation of components, relays, fuses etc. can cause faults to be stored in fault memories capable of self diagnosis. Always interrogate the fault memories after completing work on the electrical system.
  • Investigate stored faults and, once any faults have been remedied, cancel the fault memory.