13 62 593 Removing And Installing/Replacing Pressure Sensor On Left Intake Manifold (N63)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault memory of DME control unit.
Switch off ignition
Remove coolant expansion tank . See 17 11 100 REMOVING AND INSTALLING/REPLACING COOLANT EXPANSION TANK (N63) .

Unlock plug (1) and remove.

Release screws (2).

Tightening torque, see 13 62 2AZ in SENSOR FOR CONTROL UNIT .

Pull pressure sensor (3) out of left intake manifold.

Fig 1: Pulling Pressure Sensor From Left Intake Manifold

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Now clear the fault memory.