61 13... Circular connector, 20-pin, system D2.5

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Carefully press back retaining tabs (1) of internal connector (2).

Fig 1: Pressing Internal Connector Retaining Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Turn internal connector (2) until retaining lugs (1) snap into release groove (3).

Fig 2: Turning Internal Connector Until Retaining Lugs Snap Into Release Groove

Courtesy of BMW OF NORTH AMERICA, INC.

With special tool 61 0 303 press down retaining hook (4) of corresponding contact and pull out cable.

Fig 3: Pressing Down Retaining Hook Of Corresponding Contact Using Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.