61 13... Circular connector, 13-pin, system D2.5

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Pull off rubber grommet (1).

Carefully pull out lock (2) in direction of arrow.

Fig 1: Pulling Out Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Move lower section of connector (3) in direction of arrow until retaining lugs (4) snap into release groove (5).

Fig 2: Snapping Retaining Lugs Into Release Groove

Courtesy of BMW OF NORTH AMERICA, INC.

With special tool 61 0 303 , press down retaining lugs (6) of corresponding contact and pull out cable.

Fig 3: Pressing Down Retaining Lugs Of Corresponding Contact Using Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.