Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mini >> 2012 >> Cooper Base, 2D Hatchback, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4056 (Engine Electrical System - Repair - F12) >> Troubleshooting >> 61 00... Notes for disconnecting and connecting battery

61 00... Notes for disconnecting and connecting battery

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Observe SAFETY INFORMATIONS FOR HANDLING VEHICLE BATTERY .

Before disconnecting battery: 

Turn off the ignition and other electrical loads/consumers to prevent sparking when reconnecting.

NOTE: If the ignition is not turned off when the battery is disconnected, fault memories may be set in some control units.
IMPORTANT:
  • There is a danger of mixing up battery cables: If the battery positive and negative leads are the same color and you are in doubt, follow the polarity to the battery, then mark and cover the leads.
  • The on-board computer and clock may lose your data.

General notes on disconnecting battery: 

Only lead AGM battery:

IMPORTANT: The scope of application of some systems may be restricted after an open circuit.
Personal Profiles may also be lost.
Settings or activations must be carried out, depending on the equipment specification.
For example:
  • Activate slide/tilt sunroof, if necessary
  • Activate POWER WINDOW , if necessary

Refer to the diagnosis system for further vehicle-specific information.