33 17... Replacing rubber mount (with hydraulic damping)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 4 281
33 4 351
33 4 357
33 4 358
33 4 465
33 4 466

Pulling out rubber mount: Pull out rubber mount with special tools 33 4 351, 33 4 281, 33 4 466 and 33 4 465.

Fig 1: Pulling Out Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installing rubber mount: Important! Coat bearing bush in rear axle support and new rubber mount with Circo Light.

Draw in rubber mount with end shown from front into rear axle carrier. In so doing, make sure that the arrows on the rubber mount point upwards.

Fig 2: Installing Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Align special tool 33 4 358 with rubber mount using openings.

Fig 3: Align Special Tool 33 4 358 With Rubber Mount Using Openings

Courtesy of BMW OF NORTH AMERICA, INC.

Pull on rubber mount (1) with special tools 33 4 357, 33 4 358, 33 4 466 and 33 4 465 as far as it will go.

Fig 4: Pull On Rubber Mount (1) With Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.