CBS reset with diagnosis system
WARNING: This page is about a different car, the 2010 BMW 128i, 2009 BMW 128i, and 2008 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
To be able to check and/or correct the car's on-board date properly, the diagnosis system requires the correctly set tester system date!
The jobs may only be reset after the service measure has been completed.
The brake pads can only be reset with a new brake pad wear sensor.
The jobs may only be reset after the service measure has been completed.
The brake pads can only be reset with a new brake pad wear sensor.
The CBS jobs can be reset via the diagnosis system on the following path:
=> Diagnosis
=> Function selection
=> Service functions
=> Maintenance
=> CBS reset