51 11 ... Installing/Replacing License Plate (Without Base)

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Tightening torque 51 11 7AZ . See 51 11 FRONT BUMPER

Fit protective caps.

Fig 1: Identifying Drilling Hole Template On Bumper Components

Courtesy of BMW OF NORTH AMERICA, INC.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1)*.

Secure license plate (3) with license plate screw (4)*.

Tightening torque 51 11 8AZ . See 51 11 FRONT BUMPER

NOTE: *Sourcing reference: BMW Parts Service

Fig 2: Identifying Blind Rivet Nut & License Plate

Courtesy of BMW OF NORTH AMERICA, INC.