33 17 004 Replacing All Front Rubber Mounts For Rear Differential Mounting

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOLS REQUIRED:

33 3 312
33 4 161
33 4 162
33 4 166
33 4 311
33 4 312
33 4 465
33 4 466

Necessary preliminary tasks:

Remove REAR DIFFERENTIAL .

Withdraw front rubber mount with special tools 33 3 312 , 33 4 161 , 33 4 162 , 33 4 466 and 33 4 465 .

NOTE:

Milled recess of special tool 33 4 161 must point upwards to rear axle carrier.

Fig 1: Identifying Front Rubber Mount With Special Tools (33 3 312, 33 4 161, 33 4 162, 33 4 466, 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Coat bearing bushing in rear axle carrier and new rubber mount with Circolight.

Align rubber mount by way of slots (1) to vehicle transversal direction.

Fig 2: Identifying Slots

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount in special tool 33 4 311 .

NOTE:

Align rubber mount so that side slots (1) line up with marking (M) on special tool.

Fig 3: Identifying Rubber Mount In Special Tool (33 4 311)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount with special tools 33 4 465 , 33 4 466 , 33 4 166 , 33 4 311 and 33 4 312 as far as it will go.

Fig 4: Identifying Draw In Rubber Mount With Special Tools (33 4 465, 33 4 466, 33 4 166, 33 4 311, 33 4 312)

Courtesy of BMW OF NORTH AMERICA, INC.