Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mini >> 2012 >> Cooper Base, 2D Hatchback, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Specifications & Procedures) >> Wheel Alignment Procedures >> Camber Adjustment >> Front (E53)

Front (E53)

WARNING: This page does not describe the selected car, but rather 127 other vehicles, including the 2006 BMW M3, 2006 BMW 330Ci, 2006 BMW 325Ci, 2005 BMW M3, and 2005 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Changes in axle geometry caused by accidents must never be rectified by camber adjustment.
  1. Detach reservoir for windshield washer system on right side if necessary.
  2. Detach cap from wheel arch. Remove centering pin (1) with Allen key. this pin is no longer needed. Remove dirt in area of support bearing in wheel arch from below with compressed air. Slacken nut (2) approximately 1 1/2 turns. See Fig 1.
  3. Insert special tool (32 3 144/145) into opening of wheel arch and over nuts. Replace nuts (3) and screw on but do not tighten down fully. Adjust camber by turning nut in special tool. See Fig 2. Adjust camber to specification. See E53  under WHEEL ALIGNMENT SPECIFICATIONS.
  4. Tighten down nuts (3) to specification. See E53  under TORQUE SPECIFICATIONS.
  5. Remove special tool. Replace and tighten down nut (2) to specification. See E53  under TORQUE SPECIFICATIONS.
  6. Perform toe-in adjustment. See FRONT (E53)  under TOE-IN ADJUSTMENT.
Fig 1: Locating Wheel Arch Components (E53)
G00183265Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Adjusting Front Camber (E53)
G00183266Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals