Possible fault patterns during the load test
WARNING: This page is about a different variant/trim than selected.
The USB port voltage is too low.
Troubleshooting:
- Check USB cable connection between IMIB and vehicle.
- Check wires and plug connections in vehicle.
- Check the USB connection.
- Check control unit.
- Check fuse.
Load current was not reached at the USB port.
Troubleshooting:
- Check USB cable connection between IMIB and vehicle (use spare cable from another IMIB if necessary).
- The customer may have attached a USB hub (distributor) to the vehicle USB connection. Always run the USB test directly on the USB connection in the vehicle!
- Check the USB connection.
- Check wires and plug connections in vehicle.
- Check control unit.