Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mini >> 2012 >> Cooper Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 115 (Functional Description (R56) -- Cooper) >> Body Electrical System - Functional Description >> Setting the garage-door opener >> Preconditions >> 2. Programming (random code hand-held transmitter)

2. Programming (random code hand-held transmitter)

WARNING: This page is about a different variant/trim than selected.

To program the integrated universal remote control, use the operating manual of the equipment to be set. Obtain information there regarding the possibility for synchronization. When programming a random code hand-held transmitter, comply with the following additional instructions:

  1. Park the vehicle within range of the radio-remote-controlled facility
  2. Program the integrated universal remote control as described previously at 'fixed-code hand-held transmitters'.
  3. Find the button on the receiver of the equipment to be set, e.g. on the drive.
  4. Press the button on the receiver of the equipment to be set. After Step 4, approx. 30 seconds remain for Step 5.
  5. Press the programmed memory button of the integrated universal remote control three times.

The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.

scientia non olet · About Mike's Workshop Manuals