Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mini >> 2012 >> Cooper Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4056 (Engine Electrical System - Repair - F12) >> Troubleshooting >> 61 00... Notes on handling wiring harnesses and cables

61 00... Notes on handling wiring harnesses and cables

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

The following applies in general: 

To avoid damage, observe the following instructions:

The following additionally applies 

Shielded cables 

Contact points in the shield can cause problems with regard to noise radiation and interference immunity. Consequently, distinctions have to be drawn between the following types:

Coaxial cable 

CVBS cables 

HSD cables 

Fibre-optic cables: 

NOTE: Optical fibre cables are colored differently as follows:
  • Green = MOST  ( edia riented ystems ransport) optical fibre
  • Yellow = ISIS  ( ntelligent afety ntegration ystem) optical fibres
  • Orange=repair fibre-optic cables
IMPORTANT:
  • Optical fibres are permitted to show only one  junction point (bridge). Replace optical fibres if necessary
  • Smallest permissible bending radius is 25 mm
  • Avoid effects of heat ≥ 85°

Treating cables and fibre-optic cables  See 61 13... CUTTING OFF, STRIPPING INSULATION AND CUTTING OPTICAL FIBRES TO LENGTH or 61 13... CRIMPING OPTICAL FIBRES

FlexRay: 

It is possible to repair the FlexRay. In the event of damage, the cables can be joined with conventional BUTT CONNECTORS AND HEAT-SHRINK TUBING .

NOTE:
  • FlexRay lines may only reveal one  separation point (bride); renew complete line if necessary.
  • The cable is a twisted cable. If possible, maintain twisted cable after repair.

Airbag lines: 

REPAIRING AIRBAG CABLES