Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2011 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Anti-Lock Brake System (ABS) Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.
  1. Remove the Hydraulic Control Unit (HCU). For additional information, refer to HYDRAULIC CONTROL UNIT (HCU) .
  2. Remove and discard the 4 screws.
    • To install, tighten the new screws to 3 Nm (27 lb-in).
  3. Remove the ABS module.
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals