Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Acceleration Control System >> Removal And Installation >> Accelerator Pedal and Bracket >> Removal and Installation

Removal and Installation

  1. Disconnect the accelerator pedal sensor electrical connector.
  2. Remove the 2 nuts and the accelerator pedal and sensor assembly.
    • To install, tighten to 10 Nm (89 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals