Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1751 (Automatic Transaxle - AISIN Aw21) >> General Procedures >> Neutral Position Learning >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL(S)

G07785920
 Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
NOTE: When installing a new Transmission Control Module (TCM), the initialized learned values will need to be carried out.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Install the scan tool.
  3. Turn the ignition ON.
  4. The scan tool should indicate NEUTRAL.
    • If the scan tool does not indicate NEUTRAL, carry out TCM adjustment. For additional information, refer to TRANSMISSION CONTROL MODULE (TCM)  in this service information.
  5. If NEUTRAL is indicated on the scan tool, move the selector lever to PARK and turn the ignition OFF.
  6. Turn the ignition ON and move the selector lever from PARK to DRIVE.
    • The scan tool should indicate each PRNDL position.
  7. If the diagnostic display indicates each PRNDL position, check for any DTCs.
  8. If the diagnostic display does not indicate each PRNDL position, carry out TRANSMISSION CONTROL MODULE (TCM) INITIAL LEARNING  in this service information.
scientia non olet · About Mike's Workshop Manuals